Follow this explanation http://1.help.taitussoftware.com/SaVoir/help/content/6.advanced/constraints/gap/gap.htm
Category Archives: SaVoir
This is explained here http://1.help.taitussoftware.com/SaVoir/help/content/6.advanced/constraints/exclusivegrouping/exclusivegrouping.htm
See a deeper explanation here http://1.help.taitussoftware.com/SaVoir/help/content/6.advanced/constraints/duration/duration.htm
The cloud figure is a qualifier parameter, just that. The acquisition will not be planed if you have configured the sensor with a Cloud Constraint and the cloud figure is out of the defined bounds See more here: http://1.help.taitussoftware.com/SaVoir/help/content/6.advanced/constraints/clouds/clouds.htm
It has nothing to do with stereo or non stereo. Usually you leave it to zero. It allows defining sensor geometries with a certain pitch inclination, forward ot backwards.
It is usually applied to SAR sensors, whereby the satellite may have two looking sides right or left. We use the slew qualifier to allow using the same geometry figures for left or right, therefore reducing the risk of configuration errors. For optical satellites you usually consider SLew = Not applicable
Steerable continuous: Is a sensor which can be freely steerable to any intermediate position. Typically this is applicable to optical sensors mounted on board agile satellites where the full satellite platform is rolled to point to the desired looking angle. Steerable enumerative: Is a sensor which has a limited set of predefined looking positions.Typically this […]
TLEs are normally retrieved from Taitus servers, from addresses like this http://1.software.taitussoftware.com/savoir/commercial/TwoLineElements/OpticalSatellites.tles.txt Make sure your firewall is not blocking server 1.software.taitussoftware.com If TLEs are not updated for too long (> 7 days) , SaVoir will write the satellite name in red. SaVoir will nevertheless continue using the latest available TLEs for the satellite, but you can […]
This is only a temporary issue caused by changes made by NOAA to the server address. There is a workaround to solve it. In fact, we have created a new TAITUS address which redirects to the NOAA server in case they make new changes. Do as follows: (1) In “Edit / Properties / 3D engine […]